I have a used LulzBot Min v1.03 that I am selling off, I Just replaced the X-Axis Stepper with the NEW Moons Stepper. Super Quiet and Smooth. It runs Great, Works Great, Prints AWESOME !! I am ONLY selling it because this is printer 2 of 2, and really only every use one. It will need a PEI replacement or upgrade to bed Modular Bed, prints fine on the bed currently as is, NO ISSUES. There are NO Known issues, I have just run a few 7-8 hours prints on this printer with out a glitch, see Pictures Below, Printing anywhere from .15 to .30 layer Height, using Cura 21 that I downloaded from LulzBot Site.
I am Asking $675 Shipped
to the Continental US, In the Original Factory Box
- LulzBot Mini 3D Printer v1.03
- Partial Spool of Black Raptor PLA
- A couple Sample Splash Spools of Ninja Flex/ Ngen Flex as shown
Let me know if you have any questions or concerns in regards to the printer...