cura crash 1/2 way through print - two computers

Get answers & advice for all of your 3D printing & Free Software needs here!
Post Reply
derbartman
Posts: 16
Joined: Sun Dec 30, 2018 9:57 pm

cura crash 1/2 way through print - two computers

Post by derbartman » Sun Jan 06, 2019 1:11 pm

while printing this attached file cura LE(3.2.32) crashes about 1/2 way through.

I have printed other versions of this without trouble, but this one has a slight change.
As I am typing this though I am realizing I have not gone back and tried one of my older prints to confirm they are ok still.
I had it crash in the same way on two different PCs at what seemed to be the same part of the print. about 1/2 cura just goes away as an app and the printer is left waiting for more commands.
Any ideas?
I might just submit as a bug report, but wanted to see if anyone had other ideas to try etc..
I did change heads semi-recently to a areostruder - perhaps reverting to the old head might be an interesting test too.
Attachments
Part Studio 1 - Part 1-castle1.stl
(54.18 KiB) Downloaded 13 times

derbartman
Posts: 16
Joined: Sun Dec 30, 2018 9:57 pm

Re: cura crash 1/2 way through print - two computers

Post by derbartman » Wed Jan 09, 2019 9:55 pm

ok - I found some other post where a person complained of a similar issue, and in that someone suggested looking at a specific log file. I have grabbed that log file and enclosed here - it shows a Python seg fault :(
I guess I will also open a bug at this point - doesn't seem like cura should seg fault..
Attachments
stderr - mid-print-crash.log
(307.55 KiB) Downloaded 11 times

david
Aleph Objects | LulzBot
Posts: 91
Joined: Mon Apr 29, 2013 10:47 am

Re: cura crash 1/2 way through print - two computers

Post by david » Fri Jan 11, 2019 12:25 pm

Bart, I ran the stl file on my Mini 2 without incident. The file printed completely without any crash. perhaps the Rambo is causing an error? It is hard to tell.

Post Reply