dual extruder options?

Have questions? Want advice?
Post Reply
Huskerfan
Posts: 10
Joined: Sat Feb 24, 2018 10:17 pm

dual extruder options?

Post by Huskerfan » Thu Feb 07, 2019 10:06 pm

I know this is Lulzbot's web site forum but are there any alternative dual extruder's that can fit the Taz 6 out there?

I had to return mine cause it kept getting plugged.

Thanks

ajrobertsx
Posts: 13
Joined: Wed Dec 30, 2015 8:54 pm

Re: dual extruder options?

Post by ajrobertsx » Sun Feb 10, 2019 8:39 am

I think I fixed my dual extruder by adding a better 5v fan to cool the heat break. I used a fan with double the CFM than the stock one and so far have not gotten heat creep since the mod. Still experimenting on the fix.

kcchen_00
Posts: 1667
Joined: Thu Feb 19, 2015 12:42 am

Re: dual extruder options?

Post by kcchen_00 » Mon Feb 11, 2019 9:32 pm

Which dual extruder did you try?

Huskerfan
Posts: 10
Joined: Sat Feb 24, 2018 10:17 pm

Re: dual extruder options?

Post by Huskerfan » Mon Feb 18, 2019 10:47 pm

I tried the Lulzbot dual extruder but I thought maybe there was an off brand that still fits the Taz 6?

ajrobertsx, is there any soldering involved? I'm not experienced at that but I can unscrew some torx screws if I need to.

Post Reply