Increase Max Wipe Temp in Cura (above 200 °C)

Get answers & advice for all of your 3D printing & Free Software needs here!
Post Reply
cg49me
Posts: 6
Joined: Tue Nov 13, 2018 12:00 pm

Increase Max Wipe Temp in Cura (above 200 °C)

Post by cg49me » Sat Mar 16, 2019 7:27 am

Is there any way to get Cura to let me increase the maximum wipe temperature above 200 °C? I've been printing with Taulman 910 nylon on my Taz 6 using the Aerostruder head, and I've been having to manually wipe the nozzle at 255 °C in order to get the auto-level probe sequence to succeed.

Related question - is there a way to adjust the re-wipe temperature? Whenever the probe fails following the initial wipe, it drops the nozzle temp to 170 °C for re-wipes.

khaoskosmos
Posts: 4
Joined: Wed Mar 13, 2019 7:25 am

Re: Increase Max Wipe Temp in Cura (above 200 °C)

Post by khaoskosmos » Wed Apr 03, 2019 8:00 am

I have the same problem and would like to see a response.
Taz 6

kmanley57
Posts: 1109
Joined: Sun Feb 01, 2015 3:53 pm

Re: Increase Max Wipe Temp in Cura (above 200 °C)

Post by kmanley57 » Thu Apr 04, 2019 6:17 am

cg49me wrote:
Sat Mar 16, 2019 7:27 am
Is there any way to get Cura to let me increase the maximum wipe temperature above 200 °C? I've been printing with Taulman 910 nylon on my Taz 6 using the Aerostruder head, and I've been having to manually wipe the nozzle at 255 °C in order to get the auto-level probe sequence to succeed.

Related question - is there a way to adjust the re-wipe temperature? Whenever the probe fails following the initial wipe, it drops the nozzle temp to 170 °C for re-wipes.
The first one I believe is the material the wiper is made of will melt.
The second question if I remember from around a year ago posting is that that is coded into the firmware.

Both will require a change in the firmware settings and limits.
I will express my CRAZY ideas at any time! So you have been warned. None of my opinions are Lulzbots and can be wrong at any second.

Strelok_401
Posts: 3
Joined: Sat Apr 20, 2019 12:53 pm

Re: Increase Max Wipe Temp in Cura (above 200 °C)

Post by Strelok_401 » Tue Apr 30, 2019 1:24 pm

If the issues lies in the fusion temperature of the material the wiper is made of, then should that part be replaced as well? Do aftermarket alternatives exist, or should users try to jury-rig a part out of another material?

Post Reply