Why does cura crash A LOT?

Get answers & advice for all of your 3D printing & Free Software needs here!
Post Reply
oriku
Posts: 5
Joined: Tue May 14, 2019 9:41 am

Why does cura crash A LOT?

Post by oriku » Mon Jun 03, 2019 8:55 am

I keep getting this error on crashes:

OMP: Error #136: Cannot create thread.
OMP: System error #8: Not enough memory resources are available to process this command.
OMP: Error #178: Function GetExitCodeThread() failed:
OMP: System error #6: The handle is invalid.

First question is? Are you building a 64-bit executable (or only 32-bit) ?

oriku
Posts: 5
Joined: Tue May 14, 2019 9:41 am

Re: Why does cura crash A LOT?

Post by oriku » Mon Jun 03, 2019 9:24 am

One possibility is there is a handle leak in the code somewhere. Need to make sure all those handles are CloseHandle()'d appropriately.

Post Reply