Howto: Change Hexagon hotend nozzle

[kmanley57]

@Sebastian

Re-orientate the hot end to safe the heater wires

First: Be careful in this step, I consider it the most dangerous step of this howto regarding the posibility to break something.
If you recognise you can’t hand-tighten the heater block in step 3, you have to turn the heat breake inside the cooling fins. There is no thread in there, it’s only fitted together and clamped with a small screw on the back side of the cooling block.
Turn off the heater and wait until it is cooled down completely. Loosen the small screw, but don’t remove it. See the picture to know where it is:

This might be hard to do as I think the screw has high temp thread lock on it normally.