New sub forum idea, Share Gcode

I feel like it would be beneficial to new printers if there was a centralized place to allow us to share information about gcode. I had to learn the hard way several years back and would have loved to have had a goto spot where I could get help. Therefore I propose a forum dedicated to posting known good, and experimental starting / pause / tool change / filament change / sensor / etc gcodes. Different folks will have different ways to the same effect so we can all learn something.

I have a custom start, filament change, print cancel, and end code that I’d share with the community


That isn’t a bad idea. You could also start a thread in the SOFTWARE sub forum. People can post their gcode in it and your first post you can edit to maintain an organized list of the codes such as the Modification thread: