Ha…instead lets keep comparing notes. I am sure goal is the same as mine…best prints possible. I don’t care if they take a long time. I just want them to look as good as possible. I think once I get past this initial…have to print every day phase I am in… I will slow down and start going through all the initial test object calibrations they have (that can be downloaded)… hoping to squeeze a little more quality out that way too. And it could be as simple as the filament choice…room temperature…all that stuff too. Go ahead and bite the bullet and get Simplify 3D so I have someone else to bounce quality test/ideas off of. But until I get Simplify 3D more dialed in…or help from someone who knows how to set it up well for a Taz 6…then I will still use Cura for flat edge/unsupported things because I think they have it better dialed with the printer. I have no doubt Simplify 3D can get there too…just so many settings to have to work through.