I recently had to move and took the printer with me. The move was fine, nothing was jostled or broken as far as I knew. When I went to print something I noticed that the nozzle hit the first 3 probes just fine, but on the fourth and last touch it jammed down on the probe pretty hard and pushed the plate down. I heard a quick bit of noise, I assume it was from the belt grinding. After that the print started.
I’ve tried a few prints and it will either put the nozzle too far from the bed or mash the nozzle into the bed and smear the filament all over. I’m nearly certain it is because the bed is lob sided. Problem is I don’t know how to go about fixing it. Any ideas?