I’m using ABS, 110 for bed, mostly 240 for the filament. One thing I forgot I tried, was setting the filament temp to 245 for the first three layers then dropping down to 240 thereafter. I figure the bed is clean enough because after S3D failed a bunch, Cura did fine even though I didn’t do any bed cleaning (though admittedly, Cura’s supports scar more, even with tweaking the gap between support and object in expert settings).
One thing I wonder, is if the there is a way to adjust the basic Z height setting so that SC3 starts just a little bit lower. I’m thinking that if I get some extra squish on the first layer, I will get better adhesion. Is there a setting to do that?