Taz 5 Extruder Not Reaching Set Temp

[JoeBowler300]

Here’s a thread that is similar to this problem.

Taz 6 temperature calibration

I apologize if this has been covered. I searched the board but the search capabilities are pretty lame. My prints have been delaminating even at some pretty high temperature settings for a particular material, so I measured the hot end with my Fuke 87V’s thermocouple by pressing it against the hot end with a wooden dowel until the temperature stabilized. The reading were as follows. Printer Thermocouple Fluke Thermocouple Difference 220 194.5 25.5 200 175.5 24.5 180 …