Taz 6 HS+ Toolhead Thermal Runaway

Recently purchased the HS+ toolhead for a taz 6. Using stock settings for IC3D petg I am getting thermal runaway errors.

As time goes on, the print head has a harder and harder time keeping the temperature at the specified print temp and ultimately crashes the print due to a thermal runaway.

I’ve already tried slowing down the print to 20mm/s and that made it last longer before it crashed.

Ive increased temp and that does terrible things to the print.

Any other suggestions?

I would try adding a silicone sock. I found this one on Amazon.