Thank you everyone for your responses. Would have thanked you all much sooner but I don’t think I’ve set my notifications on.
I work for a cosmetics startup, and being in such environment, I was not able to systematically test each solution to actually figure out the issue.
Having said that, the issue is back again oddly enough (after a brief stint of not being able to get my material to stick to the bed which was solved with a combo of some hair spray and closing in the z-height)
Below is what I had done before to fix the issues…
- cardboard enclosure to keep things warm
- a newer laptop (the stuttering made me think that the cpu did not have enough resources to be communicating with the printer)
- Tried using PLA
- Checked and inputted filament width with digital calipers
Will be trying to mess with the multiplier rate and using an SD card. My suspicion is that the wall thickness of my object was designed at 2mm and the printer is having trouble with filling in the small space.
Below is a link to the video of what I am talking about.