Compiling Marlin from Source, Integrating *.config #defines

[mrvanes]

+1 for Klipper, I really like it on my mini + octoprint

Klipper 3D firmware replacement

A fresh Klipper 3D topic for anyone interrested in switching from Lulzbot Marlin to Klipper and needing some assistance to complete the move At the moment of writing, there are 3 working Klipper Lulzbot configurations: (a slightly modified version of) Mini 1 2016 Taz 2017 Taz dual v3 2017 Klipper 3D needs a host to run the Klipper gcode parsing firmware (e.g. the Raspberry Pi that also runs Octoprint) and sends simple stepper/heater/fan-pin instructions to a dumbed-down printer firmware. The…