Cura 2.1 Beta

[movingimage]

I’d like to test the new Cura 2.1 Beta that Ultimaker has released. It looks like there are many improvements. I believe it requires a .json file with the TAZ5 configuration to work properly though. Has anyone given this a shot?

Best,
J

[kmanley57]

@movingimage

I’d like to test the new Cura 2.1 Beta that Ultimaker has released. It looks like there are many improvements. I believe it requires a .json file with the TAZ5 configuration to work properly though. Has anyone given this a shot?

Best,
J

Check here:

How to hack Cura 2.1 for LulzBot 3D Printers

For the past 18 months Ultimaker has been hard at work on a new generation of Cura. The user interface has been completely redesigned and a huge amount of work has been put into the slicing engine too. This post provides an overview of what has changed. For more details read the full release notes: https://ultimaker.com/en/blog/21263-cura-212-has-been-released Also included in this post is instructions on how to adopt this version of Cura so that it can be used with LulzBot 3D printers. This wil…

I can try and package up them if needed.

[movingimage]

Thank you!

Now it looks like 2.3 Beta is out & has some major improvements!