Cura 21.00 Supports are worse?

Upgraded from veison17 to 21 due to upgrading a tool head on my taz4 to the 2.0 with .5 nozzle

The new supports are harder to remove, they do not break away cleanly and mar the surfaces on my prints. I used to be able to snap off supports in a matter of seconds and it would still leave a nice surface… now…its a mess.
is there a way to use the old supports in the new cura? Perhaps are hard to find setting?

Or should just go back to the old version?

Click the “…” next to “Support type”. In the new dialog box, change the “Distance Z” to .3mm… or the distance of one layer.