Dual Extruder Calibration Taz Pro

[gary2506]

I think I found the answer in this thread thanks to TheVirtualTim

Taz Pro Nozzle Calibration Variation

I have been having some z-offset problems with my Taz Pro. When printing, the nozzle is lower than I would expect it to be and it is hitting the existing print as it goes. On multiple occasions it has actually knocked prints off the bed… Lulzbot support has suggested manually adjusting the z-offset. What is the difference between the ‘Nozzle Offset’ z value and the ‘z offset’ value? When I have done the ‘Automatic Calibration’, I end up with different ‘Nozzle Offset’ z values every single time…