Fan queston for you gurus

[Wolfie]

@choban

Wolfie
Can you share what the hexagon mounting plate looks like for a double side cooling fan. Are you using a standard Hexagon hot end or the one that ships with the TAZ 5.

Full load of images from the project are in this album:
http://www.ipernity.com/doc/wolfie/album/773974

Here is one of the images of the plate:

Yes, I am using Lulz’ version of the Hex hot end. The reprap one is distinctly longer.

Full details of the build is in this thread here on the forums:

30/40mm Heat Sink Fan for Taz + Hexagon

I thought some folks might not stumble into the other thread that wasn’t titled well for this project. So I collected the relevant posts into this one initial post so the thread has a collective home that is properly titled. Here is the new fan shroud and mount plate: http://www.thingiverse.com/thing:766633 Enjoy. Let me know if you build one and what your results are. The following hardware list assumes you would be converting an existing single hex extruder head from Lulz and would be us…