General interest in an improved controller PCB?

[mwester]

A quick scan of topics here comes up with these threads that may provide some insight:

Klipper 3D firmware replacement

A fresh Klipper 3D topic for anyone interrested in switching from Lulzbot Marlin to Klipper and needing some assistance to complete the move At the moment of writing, there are 3 working Klipper Lulzbot configurations: (a slightly modified version of) Mini 1 2016 Taz 2017 Taz dual v3 2017 Klipper 3D needs a host to run the Klipper gcode parsing firmware (e.g. the Raspberry Pi that also runs Octoprint) and sends simple stepper/heater/fan-pin instructions to a dumbed-down printer firmware. The…

Einsy Rambo 1.1 Mini 1

So let’s say I were getting an Einsy Rambo to put in my original Mini. What are thoughts on the best way to deal with the firmware for that? I’m not particularly concerned about catching skipping or power loss etc right now, I mostly just want my mini to be quieter. The two most likely scenarios seem to be recompile the mini 1 firmware with options for taking advantage of the quieter trinamic drivers or waiting for the mini 2 firmware and setting the print area to match the mini 1. I haven’t loo…