High Temp Bed for TAZ 6?

Hello everyone.
I was wondering if someone modified the TAZ 6 by using a 3rd party high temp bed (140C +).
I would be interested in where to get it and how to install/connect it and if firmware modification are also necessary?

Thanks a lot!

Wiggi

NASA modified a Taz 4 for high-temp printing. They don’t mention any changes needed on the bed.

  1. Pre-heat bed to print temperature (>162°C). It is recommended that this step be completed while the material is in the oven, as the bed can take >15 minutes to reach temperature

Pretty involved writeup here: High Temperature Thermoplastic Additive Manufacturing Using Low-Cost, Open-Source Hardware (nasa.gov)

Thanks a lot, Wrathernaut