Mini Printing Issues

General LulzBot Mini
1

Hey Lulzbot Comm,

I have been having a few issues with my brand new mini and after some troubleshooting cannot figure out why its happening. As seen here: https://carousel.dropbox.com/photos/cc/00voAMfp8XN0mCv - I am getting warping and in some cases scorching of the lower parts of my prints. I have tried adjusting the temps of the bed and nozzle with no help.

Anyone have any suggestions?

2

What type of filament? And what temps?

3

ABS plastic, bed at 90 and nozzle at 240 printing speed at 50.

4

Those extrusion and bed temps seem fine for ABS. I often start the print on a 110C bed and gradually tsper off to 90C. Ofteneint in white with no discoloration of the part.

Cam you describe where the scorching is on the shared pics…