Here’s a couple of photos of the result. I think there’s still some room for improvement. A little sanding and a quick pass with a pen torch cleaned things up a bit better too. If I adjust the supports a little, it should make for some easier cleanup too.
The print looks worse in the photo because of the reflections
Looks like hair spray is the key. Also, a first layer at a higher temp. The second print using this method worked even better than the first. At some point I may try and eliminate the solid base.
Scott
Two wheels printed. I need to improve my technique for joining the two halves together.
Cheers,
Scott
Have you refined your technique for printing machinable wax since you last posted? Wonder if you’ve developed a reliable method.
Thanks,
Aaron
What lultzbot did you use? Do you currently use wax, or have you compromised to another filiment?
still printing with wax ? how’s it going if you are…
