Rubber feet on Y axis rails

[zenotek]

TAZ 6 - Just noticed the Y-Axis Doesn't Touch the Table

I will add pictures to this post when I get home and can take some, but I noticed last night that the 4 corner feet of the Y-axis don’t touch the desk that the printer sits on. The main housing appears to be square (I saw the bulletin about a production run where the frame could go out of square during shipping). Anyway, in cleaning up some filament particles from the desk I noticed the front right corner pad wasn’t touching the desk (it was about 2mm high). In looking at the others I then notic…

Something something cats.