Thanks! I don’t have issues connecting and communicating through Cura Monitor, so I can likely go that route.
Also, I haven’t tried any PLA parts since I started seeing this, so I have not tried printing at lower temperatures, but my TAZ 5 came with a spool of HIPS, so my first few prints were at around 250c and I didn’t have these same issues.
I’ll try to run the gcode commands this evening and report back with what the outputs are. If I need to do some PID tuning, I will need some help. I did a little in college, but that was way too long ago for me to remember 
Best,
Ben