Taz Workhorse great but heating time out?

Hi team. Just upgraded my old Taz 5 to a Workhorse and its great, just what I wanted. But I notice what I assume may be a firmware change.

I always print in ABS, and some of my parts are big, flat and thin. I used to head the bed well in advance, which seemed to get the whole enclosure etc at a nice stable temp and eliminated warpage.

With the WH, the heating times out after a few minutes if I haven’t hit Print. Is this something I can adjust or toggle off? Just wondering if you can set the time before time out, or maybe just disable it?

Thanks in advance.

The firmware is set to timeout after 15 minutes. This is a safety feature that is added that can not be turned off.