Bed temp after print

Ok guys,

My TAZ 5 has developed a mind of its own.
After a print our TAZ has decided to start parking the head at it max height and the bed is staying heated until reset.
I am not sure if someone changed a setting somewhere but I cannot find where it is set to tell it to do this. We are currently using Cura to print. I don’t see any setting in the basic advanced or expert settings. There are a couple of plug-ins loaded but I don’t think that they are active.
Anybody have any Ideas.

Hi Corr

It seems some body has changed your End-GCode.
You can find that in the expert settings. Below you find the ones for my Mini.
There the positions are slightly different :wink: