Average time to reach temps on heatbed

General LulzBot TAZ
1

This question is specifically for those that have the TAZ Modular Print Bed System which consists of the TAZ Pro/Workhorse Magnetic Flex Bed and the TAZ Modular Print Bed Heater.

Yesterday I was testing out the hotends and the heatbed. Just making sure they were working. I only set the hotends to reach 120 and the heatbed to 60. It made those temperatures ok, but seemed like it was taking longer than it should have for the heatbed. I then turned up the heatbed to 70. It reached that ok, but felt like it was a little show. I didn’t time anything.

So what kind of times do people see when going from room temperature to 60 or 70 or higher on the heatbed?

2

Heated yes but the workhorse is their a 2024 or earlier model (upgraded to a magnetic bed) or (Taz workhorse plus years 2024-present) both yes but as of the pro I would be pretty sure but I would need to outreach on that one

Also it could lend up a hand at assisting you if we know which taz pro’s you have in mind

3

I installed the TAZ Modular printbed system on my Taz 5 that I am rebuilding.

I am just trying to get some idea of what to expect for heating times.

4

TAZ 6 with Modular Print Bed Heater and Magnetic Flex Bed. Room Temp to 100c.

image
image618×367 31.8 KB

Sorry about the glitch but a plugin was set to timeout at 10 minutes.