Just today, my extruder motor stopped responding to commands/prints. I tried swapping the wires for my extruder and x motor. Then, when I sent a command to “move x”, it extruded. But when I sent a command to extrude, it didn’t move the x. Nothing happened.
Does this mean the extruder port on the Rambo is bad?
The problem lies with the RAMBo electronics/mosfet/driver. If you think you are still under warranty,send in the following information to Support@LulzBot.com:
Order number
3D printer serial number
Contact information
Shipping information
and we’ll see what needs to happen, to get you up and running again!