Well the conversion to E3D-v6 is complete.
I did have to make my own filament fan shroud as both the ones I got on Thingiverse were not the right height. Piercet yours was too high up and could not be bolted to the original mount (I did not want to reprint the entire set you made). The other I got (linked to in first post) was actually too low and it would have crashed into the bed.
Also I ended up printing the E3D mount myself as the nice aluminum one I bought was very sloppy and I didn’t want that. I made my own and made it fit very snug (I posted it on Thingiverse if anybody wants it http://www.thingiverse.com/thing:1749234 ).
In the end the only other thing I had to do was run the PID auto tune (it was hard to find instructions but easy to do once I did).
I have only printed a few things so far and all in ABS but I am hoping that PLA has no more heat creep issues.
