I have a Taz 5 with Dual Extruder V3. I only got to use it for a month or so before I had to go abroad for work. 6 months later I’m back and got the Taz all setup, upgraded the firmware and was ready to go. MINTEMP ERR HALTED PLEASE RESET. every single time so far.
I did a search on this and the amount of topics was a bit overwhelming. But obviously there is something going on for it to be occurring so much.
Has there been a single thing or consensus that is causing this? I saw the post about the dual is the serial number is a certain set. Mine isn’t one of those. And my printer is pretty tip top. Any clues would be appreciated.
Frustrated but optimistic