Hi. I appreciate your feedback. I do have the TAZ 2 and the budaschozzle 2.0 and I will make sure to re-slice at the correct diameter. For now im just calibrating it.
I mounted the nozzle and I realized that I didn’t make any marking on the nozzle mount as to how the previous nozzle aligns. How do i ensure the nozzle is centered in the mount?
Currently when i do a bed calibration test, the perimeter square is slightly to the left and a bit tilted from how it was printing with the stock nozzle. To fix this i assume i just play with the nozzle alignment to the nozzle mount?
Does it even matter if the bed calibration test is not perfectly in the center of the bed? - as long as its not off the bed, or too close to one side?
Thanks
Aaron