TAZ 4 in Cura 3.2.32

I wanted to try out Cura after using Simplify 3D for so long, so I downloaded the latest Lulzbot version but noticed there is no TAZ 4 listed.

Now, my TAZ 4 has a E3D hotend as well.

Any hep setting up Cura properly?

Keep in mind while not a 100% noob with Cura I am a 90% noob at Cura.


Depending on your setup, you can start with the TAZ 5 profiles. Ideally, you’ll have moved away from the green PET film to a PEI print surface. You may need to adjust some of the built-in temps to better suit your exact hot end setup and performance.