Taz 6 E3D

just a quick question - If i were to upgrade the hotend to the e3d v6 is the overall process the same for the Taz 5 extruder or is it a bit more complicated (other than the autolevel sensor). Here’s the guide on the Taz 5 conversion. http://matterhackers.dozuki.com/Guide/How+to+Install+an+E3D+v6+HotEnd+on+a+Lulzbot+TAZ+5/5

Oh and I guess which hot end voltage am I looking at - not sure about the heater block voltage