I got a little too excited about getting my hot end back [it works! yay!] and forgot to take the foam blocks off of the Y axis rails and started up a print. The bed pressed against the blocks and made noise, so I immediately stopped the print and turned off the motors in cura, then took off the blocks and tried again. Now, the end stop at the back of the bed is perpetually registering as pressed, even though I have checked and it is clear of obstructions. The connectors seem fine, too.
Anything more I can do before going to the support team?
Did you power cycle the printer? I had an endstop issue once where power cycling cured it. Also, love your icon! 