I just updated the firmware on my Mini to the latest version that comes with CuraLE 3.6.18, it was originally on an old firmware from 2016, Cura 18.03 or something. I recorded by e-step and z-offset before the update, but after updating whatever figure I enter for the e-step isn’t saving.
Before I did the firmware update, I was getting this from M501;
M92 X100.50 Y100.50 Z1600.00 E833.00
After the firmware update, M501 gives me this;
M205 B20000 S0.00 T0.00 X12.00 Y12.00 Z0.40 E10.00
And any time I enter M92 E833 (and M500 to save) it remains at E10. Has the M92 command changed? As it’s even echoing M205 now?