Hey I’m fairly new to 3D printing and Cura but I’ve recently ran into a problem after trying to update the drivers to see if it would help with my prints. Unfortunately now I cannot print due to every time my lulzbot mini tries to set itself home it goes to the negative on the y axis and doesn’t stop. While I’m in my console and try to move on the x or y axis, the steps are HUGE compared to how far it used to move when clicked. I’m not sure what I need to change and I’ve already tried uninstalling and reinstalling Cura, uninstalling the drivers and forgetting the drivers. I really need my 3D printer to be up soon so any help would be appreciated.