I got my Taz 6 last week and I LOVE it. I have all sorts of 3D designs I have been building up over the last several months as I got progressively more serious about the purchase.
Many of these prints take hours and I need to leave the printer alone and I will not be present when it finishes up. So, I want things to be shut down as much as possible at the end of printing.
Normally, the bed cools off to somewhere around 45 then the bed moves forward at the end of printing. I tried inserting M140 S0 just before the very last line of the “End Gcode” in the advanced settings (after the bed is moved forward upon cooling to around 45 or whatever the default code says). On one occasion it seemed to work, but yesterday, the bed never moved forward and only cooled off to the default setting. So, something I did messed up the code. What should I insert (and where?) into the default end gcode to turn off the bed heater completely.
Also, the fans seem to continue turning at a slow speed despite the default code (M107, as I recall) should be turning the fans completely off. Is there a way to get them to turn completely off.
Alternatively, It would be fine by me if the printer were to shut off completely at the end of the print job. Is there a GCode instruction to make this happen?