Nozzle Drag on Mini

I have done three prints on my new mini using HIPS from lultz and I can see and hear the nozzle tip dragging through my prints. I’m very new to 3d printing and have no idea what is going on (Or what I am doing wrong). I am using the quick print profile on cura.

Not sure but there is a mini dedicated category here Some similar postings.

Sounds like too much filament being extruded…

Lower through the flow /extrusion multiplier in your slicing software. Or the other way to compensate is to spot check the diameter of the filament and adjust the setting accordingly in software.