TAZ6 misses leveling washer when traveling to it.

This has just started and doesn’t happen all the time. The nozzle levels at the front two washers. But when it traverses to the right rear washer if falls a little sort of even getting there and the nozzle presses in to the bed. ???

Reach out to the support team at LulzBot.com/Support. They’ll be able to walk you through a quick check of your hardware. Some homework: check that the bed and tool head have a full range of travel and that nothing is blocking the endstops at the left hand side of the x-axis, and at the rear of the y-axis. You should hear an audible click when at the end of the travel range. Grab the latest firmware included within the current version of Cura LulzBot Edition as well.