Trying to set up "One at a time" Printing

General Software
4

Well thanks for linking me to the discussion. :laughing:

Also, I can’t search for “one at a time printing” because it says there are too many small words.

When I look up Sequential printing all I find is a post about a feature they want to be included in the future.

I’ll keep looking

Edit: Only been able to find this post "Printer Head Size in Cura - #11 by nopick going to see if these dimensions work. Thanks for the tip on searching for “Sequential printing” instead!

Edit 2: Just made these changes, but the printer still will not even attempt to print the objects one at a time. Nozzle is still moving from object to object. Putting down one layer then moving back to the other object.