I have added a BLTouch to my Taz6 printer and downloaded the Drunken Octopus Firmware directly to my printer. When I first added the firmware it would touch down in the center of the build plate 1x. I was wanting it to create a mesh of the build plate touching down 9x. I added G-code to starting script in simplify 3D and now the printer keeps trying to home Z on the washer but is still deploying the BLtouch system. I cannot figure out how to get it to go back to the middle of the build plate to start the Z homing process. I tried re- installing the original CURA firmware then uploading the DO firmware again to see if it would reset but it didn’t work. Any help to resolve this would be greatly appreciated!