Lulzbot Cura question

I am using the most up to date cura edition (from lulzbot site).

When my print finishes the bed moves to the back, and the hot end cuts off BUT the bed just cools down to 45 and stays there…nothing else ever happens.

What I thought was supposed to happen (I am new) was that once the bed cools down to below 45 the bed would move back forward and the bed would cool down to room temp.

It holds 45 overnight (ask me how I know lol)

Please post your gcode under the Start/End G-code tab and then click “end.gcode” and copy and past the code shown below that. That will tell us what’s going on.

Jiim